The other settings don’t matter in this use case.Set all three (foreground, background, device locked) cycle timing to.Scroll to the bottom and enable broadcast intent on visible only.Tap the beacon that was found and name it to the Room or Location you plan to use.At this point you may want to also block notifications from this app. Do a scan to find your Beacon, press the play button, you’ll want to stop this after your beacons are seen.Android Settings >Apps >Permissions, enable Locations. Check the permissions for this app… it seems the developer did not check permissions for Location.when a new beacon is selected as the Location the presence sensor for “User BeaconName” will be set to present and all others will be not present.ĪutoTools used to make easy dialogs/average large numbers Once you stop moving this will continue to scan for several seconds. Whichever Beacon’s avg rssi is closest and with the most number of pings is the location. Auto tools will then average all of the pings to determine the average RSSI (recieved signal strength indicator). Tasker will not scan continuously while walking, but every few seconds. The beacon radar app reports every ping back to tasker. Once the user is home the app will wait for you to walk, once you start walking it will scan for beacons. Basically the same as this post This will then set a smartthings presence sensor “User Home” to present. How this works, uses Autolocation and wifi connected to determine if you are home. This uses very little power and should be relatively simple to setup. I have created an app that uses several tools to determine overall and precise locations within the house using beacons.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |